KTM F7360R6, Owner'S Manual

Page: 77 / 178

12 SERVICE WORK ON THE CHASSIS
75
V00340-11
–
Mount and tighten screws
2
.
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the headlight mask with the headlight. ( p. 120)
–
Check the headlight setting. ( p. 122)
12.18 Removing the shock absorber
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 63)
E00834-11
Main work
–
Remove screw 1 and lower the rear wheel with the swingarm
as far as possible without blocking the rear wheel. Secure the
rear wheel in this position.
–
Remove screw
2
, push splash protector
3
to the side, and
remove the shock absorber.
12.19 Installing the shock absorber
E00834-10
Main work
–
Push splash protector
1
to the side and position the shock
absorber. Mount and tighten screw
2
.
Guideline
Screw, top
shock absorber M12 80 Nm (59 lbf ft)
Loctite ® 2701™
–
Mount and tighten screw 3 .
Guideline
Screw, bottom
shock absorber M12 80 Nm (59 lbf ft)
Loctite ® 2701™
Info
The heim joint for the shock absorber at the swingarm
is Teflon-coated. It must not be greased with grease or
with other lubricants. Lubricants dissolve the Teflon
coating, thereby drastically reducing the service life.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 63)