11 SUSPENSION SETTING
38
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
11.15
Handlebar position
M01659-10
On the upper triple clamp, there are 2 holes at a distance of
A
to
each other.
Hole distance
A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
B
from the center.
Hole distance
B
3.5 mm (0.138 in)
The handlebar holder can be mounted in four different positions.
This allows the handlebar to be mounted in the most comfortable
position for the rider.
11.16
Adjusting the handlebar position
Warning
Danger of accidents
A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
M01659-11
–
Remove screws
1
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and
tighten screws
2
.
Guideline
Screw, handle-
bar support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
Mount the left and right handlebar supports in the same
position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
1
and tighten
evenly.