KTM Chassis 690 SMC, Owner'S Manual

Page: 124 / 186

MAINTENANCE WORK ON CHASSIS AND ENGINE
122
100160-10
–
Remove the screw from the rear of the flasher housing.
–
Tilt headlamp diffuser

forward carefully and take it off.
–
Press the flasher bulb carefully into the socket, turn it counterclockwise by about 30°,
and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new flasher bulb carefully into the socket and turn it clockwise until it stops.
Flasher light (BAU15s) ( p. 164)
–
Position the diffuser.
–
Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
–
Check the flasher system function.
9.66
Checking headlamp setting
0 0 B B
0 0 A A
400408-10
–
On a light-colored wall with a horizontal area in front of it, make a mark as high as the
center of the low beam headlight.
–
Make another mark at a distance of

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Stand the motorcycle at a distance of

in front of the wall and switch on the low
beam.
Guideline
Distance

5 m (16 ft)