KTM 990 Supermoto R, Owner'S Manual

Page: 186 / 220

CLEANING
184
13.1
Cleaning motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
Never clean the vehicle with high-pressure cleaning equipment or a strong water-jet. The excessive pressure can penetrate electrical
components, socket connects, throttle cables, and bearings, etc., and can damage or destroy these parts.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
–
Close off the exhaust system to keep water from entering.
–
Remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a paintbrush.
Motorcycle cleaner ( p. 211)
Info
Clean the vehicle using warm water containing normal motorcycle cleaner and a soft sponge.
If the vehicle was operated in road salt, clean it with cold water. Warm water would enhance the corrosive effects of salt.
–
After the motorcycle has been thoroughly cleaned with a gentle jet of water, it should be dried with compressed air and a cloth.