KTM 990 SMT, Owner'S Manual

Page: 138 / 219

ELECTRICAL SYSTEM
136
13.9
Changing the turn signal bulb
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
101147-10
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser

.
–
Press bulb

carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
Turn signal (RY10W/socket BAU15s) ( p. 195)
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.
13.10
Changing the brake light bulb
Note
Damage to reflector
Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Remove the seat. ( p. 83)