KTM 990 Adventure R USA 2010, Owner'S Manual

Page: 147 / 225

MAINTENANCE WORK ON FRAME AND ENGINE
145
–
Switch off the ignition by turning the orange programming key to the OFF position .
–
Pull out the programming key.
–
Insert the black ignition key in the ignition lock.
–
Switch on the ignition by turning the black ignition key to the position ON .
FI Warning lamp ( MIL ) lights up, switches off, and then starts to flash.
Immobilizer indicator lamp lights up, switches off briefly, and lights up
again.
–
Switch off the ignition by turning the black ignition key to the position OFF .
–
Remove the black ignition key.
–
To activate further ignition keys, repeat the last 4 steps with the respective ignition
key.
–
Insert the orange programming key in the ignition lock.
–
Switch on the ignition by turning the orange programming key to the ON position .
FI Warning lamp ( MIL ) lights up, switches off, and then starts to flash.
Immobilizer indicator lamp lights up, switches off briefly and flashes; the
number of flashes equals the number of functional black ignition keys includ-
ing the orange programming key.
–
Switch off the ignition by turning the orange programming key to the OFF position .
–
Pull out the programming key.
All black ignition keys are activated included in this job sequence are activated.
Removing the storage compartment and hanging it to one side
x
–
Remove the seat. ( p. 76)