MAINTENANCE WORK ON CHASSIS AND ENGINE
131
100601-10
–
Turn bulb socket
counterclockwise all the way and take it out of the tail light.
–
Press bulb
carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
Brake light (PR21W / socket BAW15s) (
–
Insert the bulb socket into the tail light and turn clockwise until it stops.
–
Check the lighting function.
–
Position the tail light. Mount and tighten nuts with the washers.
Guideline
Nut, tail light
M6
8 Nm (5.9 lbf ft)
9.61
Checking the headlamp setting
0
0
A
A
0
0
B
B
400609-10
–
On a light-colored wall behind a horizontal area, make a mark as high as the center of
the low beam headlight.
–
Make another mark at a distance of
under the first mark.
Guideline
Distance
5 cm (2 in)
–
Position the motorcycle at a distance of
away from the wall. The rider, with luggage
and passenger if applicable, now mounts the motorcycle.
Guideline
Distance
5 m (16 ft)
–
Switch on the low beam. Check the headlamp setting.
The light-dark boundary must lie exactly on the lower mark when the motorcycle is
ready to operate with the rider mounted along with any luggage and a passenger if
applicable.
Summary of Contents for 990 Adventure 2009
Page 2: ......
