13
WHEELS, TIRES
106
M01388-10
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Mount wheel spindle
and chain adjuster
. Mount nut
, but do not tighten it
yet.
–
Make sure that chain adjusters
are fitted correctly on adjusting screws
.
–
Make sure that the markings on the left and right chain adjusters are in the same posi-
tion relative to reference marks
. The rear wheel is then correctly aligned.
–
Tighten nut
.
Guideline
Nut, rear wheel spindle
M25x1.5
90 Nm
(66.4 lbf ft)
–
Position the wheel speed sensor
in the drill hole. Mount and tighten screw
.
Guideline
Screw, wheel speed sensor
M6
6 Nm (4.4 lbf ft)
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
Finishing work
–
Remove the rear of the motorcycle from the wheel stand. (
–
Check the chain tension. (
13.5
Checking the rear hub rubber dampers
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They eventually wear out during
operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub become damaged.
Summary of Contents for 690 SMC R
