KTM 690 SMC 2008, Repair Manual

Page: 166 / 227

41/THROTTLE VALVE BODY
164
–
Fix screws

with locking varnish.
–
Press "Continue" .
–
Read the information page on the KTM diagnostics tool and, using "Continue" , start
the "ECU Reset" menu.
The control unit is reset.
–
Complete the procedure with "Continue" .
601136-10
–
Switch off the ignition by turning the ignition key in the position (690 SMC EU,
690 SMC AUS/UK) (690 SMC USA).
–
Plug in the connector of the motor drive DR

.
–
Switch to the main menu.
–
Switch on the ignition by turning the ignition key in the position (690 SMC EU,
690 SMC AUS/UK) (690 SMC USA).
–
Select model.
–
Select "ECU Diagnostics" .
–
Highlight "EPT throttle motor drive control LC4" control unit.
–
Press "Continue" .
–
"Read trouble code" selected.
–
Complete the procedure with "Back" .
–
Select "Delete trouble codes" .
–
Complete the procedure with
"Back"
.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and perform an initialization run.
Guideline
Initialization run 15 min
24.3
Flashing the EFI control unit and/or the EPT control unit
Condition
The ignition is on.
The diagnostics tool is connected and running.
400687-60
EFI control unit
–
Select model.
–
Select "ECU Diagnostics" .
–
Highlight the
"Injection management EFI LC4"
control unit.
–
Press
"Continue"
.
–
Select "ECU Flashing" .
–
"Please enter the password:"
–
Press "Continue" .
–
Read the safety instructions and create the necessary preliminary conditions.
–
Confirm the instructions by clicking on "OK" .
–
Press "Select file" and select a new mapping.
Info
"The BLZ file and the exhaust system must match!"
–
Press the "ECU flash process" button.
–
Read the prompt and confirm with "OK" .
The new mapping is loaded.
–
Switch to the main menu.