38/LUBRICATION SYSTEM
155
100201-01
–
Thoroughly clean the oil drain plug with a magnet.
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Refit the oil drain plug with the magnet and seal ring and tighten it.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
22.6
Removing the oil filter
Warning
Danger of scalding
Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Place a suitable container under the engine.
100202-10
–
Remove screws
. Remove the oil filter cover
with the O-ring.
–
Pull oil filter
out of the oil filter housing.
Circlip pliers reverse (51012011000) (
100203-10
–
Remove screws
. Remove oil filter
with the O-ring.
–
Pull oil filter
out of the oil filter housing.
Circlip pliers reverse (51012011000) (
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
22.7
Installing the oil filter
100204-10
–
Insert oil filters
and
.
–
Oil the O-rings of the oil filter covers. Mount oil filter covers
and
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
M5
6 Nm (4.4 lbf ft)
Summary of Contents for 690 SMC 2008
Page 1: ...REPAIR MANUAL 2008 690 SMC EU 690 SMC AUS UK 690 SMC USA Article no 3206042en...
Page 2: ......
Page 185: ...183...
