30/ASSEMBLING THE ENGINE
146
19.31
Installing oil screens
300152-10
–
Push the oil screen with O-rings on to a pin wrench. Push the pin wrench through
the opening into the drill hole of the opposite engine case wall and push the oil
screen as far as possible into the engine case.
300008-10
–
Install the oil drain plug with magnet
and a new seal ring and tighten it.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
–
Install and tighten the plug
with O-rings.
Guideline
Plug, oil screen
M20x1.5
15 Nm
(11.1 lbf ft)
300161-11
–
Position the oil screen
with O-rings.
–
Install and tighten the plug
with O-rings.
Guideline
Plug, oil screen
M20x1.5
15 Nm
(11.1 lbf ft)
19.32
Installing alternator cover
300005-10
–
Apply sealing compound lightly in the area of the cable support sleeve.
–
Install the dowel
. Put on the alternator cover seal.
300004-11
–
Position the alternator cover.
–
Mount and tighten screws
.
Guideline
Screw in alternator cover
M6
10 Nm (7.4 lbf ft)
–
Mount and tighten screw
.
Guideline
Screw, alternator cover
(chain shaft through-hole)
M6
10 Nm
(7.4 lbf ft)
Loctite
®
243™
Summary of Contents for 690 SMC 2008
Page 1: ...REPAIR MANUAL 2008 690 SMC EU 690 SMC AUS UK 690 SMC USA Article no 3206042en...
Page 2: ......
Page 185: ...183...
