KTM 690 Enduro R AUS, Owner'S Manual

Page: 129 / 190

ELECTRICAL SYSTEM
127
800100-10
–
Pull bulb socket

out of the reflector.
–
Pull parking light bulb

out of the bulb socket.
–
Insert a new parking light bulb in the bulb socket.
Parking light (W5W / socket W2.1x9.5d) ( p. 168)
–
Insert the bulb socket in the reflector.
–
Install the headlight mask with the headlight. ( p. 124)
13.10
Changing the turn signal bulb
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
100301-10
–
Remove the screw on the rear of the turn signal housing.
–
Tilt headlamp diffuser

forward carefully and take it off.
–
Lightly squeeze the orange plug

in the area of the holding lugs and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.