KTM 690 Enduro R AUS, Owner'S Manual, Page: 110 / 190

WHEELS, TIRES
108
12.4
Installing the rear wheel
x
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Check the rear hub rubber dampers. x ( p. 109)
100269-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing. x
–
Remove bushing

. Clean and grease the working surfaces of the bushing and shaft
seal ring

.
Long-life grease ( p. 180)
–
Clean and grease the thread of the wheel spindle and nut

.
Long-life grease ( p. 180)
–
Install the rubber damper and rear sprocket carrier in the rear wheel.
–
Place the rear wheel in the swingarm and bring the brake disc on the brake caliper into
contact.