KTM 690 Enduro AUS 2010, Repair Manual, Page: 87 / 265

11/WIRING HARNESS, BATTERY
85
Warning
Fire hazard
The electrical system can be overloaded by the use of incorrect
fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
–
Replace with a spare fuse of the right rating.
Fuse (75011088010) ( p. 191)
Fuse (75011088015) ( p. 191)
Tip
Put a new spare fuse in the fuse box for future use if needed.
–
Checking the function of power consumers.
–
Close the fuse box cover.
–
Mount the seat. ( p. 66)
14.9
Adjusting the engine characteristic
–
Switch off the ignition by turning the ignition key to position OFF .
–
Remove the seat. ( p. 66)
100237-10
–
Pull the Map
‑
Select switch and holder

upward off of the retaining bracket.
–
Pull the Map
‑
Select switch out of the holder.
100238-10
–
Turn the adjusting wheel until the desired digit is next to marking

.
Set the Map
‑
Select switch to Soft.
–
Set the adjusting wheel to position 1 .
Soft
–
reduced homologated peak performance for better driveability.
Set the Map
‑
Select switch to Advanced.
–
Set the adjusting wheel to position 2 .
Advanced
–
homologated performance with extremely direct responsive-
ness.
Set the Map
‑
Select switch to Standard.
–
Set the adjusting wheel to position 3 , 4 , 5 , 6 , 7 , 8 or 9 .
Standard
–
homologated performance with balanced responsiveness.
Set the Map
‑
Select switch to poor fuel quality.
–
Set the adjusting wheel to position
0
.
Poor fuel quality
–
homologated performance is reduced in accordance with
the fuel quality, use for no more than 1 tank of fuel
–
Position the Map
‑
Select switch in the holder.
–
Slide the Map
‑
Select switch with the holder downward onto the retaining bracket.
–
Mount the seat. ( p. 66)