KTM 690 DUKE R EU, Owner'S Manual, Page: 129 / 179

15 COOLING SYSTEM
127
15.4 Draining the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water immedi-
ately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swallowed,
contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of children.
Condition
The engine is cold.
B00984-10
–
Stand the motorcycle upright.
–
Place a suitable container under the engine.
–
Remove screw

. Remove the radiator cap.
–
Completely drain the coolant.
–
Mount screw  with a new seal ring and tighten it.
Guideline
Plug, drain hole of water pump M10x1 15 Nm
(11.1 lbf ft)