KTM 690 DUKE R AUS/UK, Owner'S Manual, Page: 119 / 187

ELECTRICAL SYSTEM
117
100160-10
–
Remove the screw on the rear of the turn signal housing.
–
Tilt headlamp diffuser

forward carefully and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
Turn signal (RY10W / socket BAU15s) ( p. 162)
–
Position the diffuser.
–
Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
–
Check that the turn signal system is functioning properly.
13.12
Checking the low beam headlight adjustment
0 0 A A
0 0 B B
400726-10
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically at a distance

in front of the wall and switch on the low
beam.
Guideline
Distance

5 m (16 ft)