KTM 690 DUKE MAL, Owner'S Manual, Page: 135 / 197

14 ELECTRICAL SYSTEM
133
B00981-10
–
Remove the screw on the rear of the turn signal housing.
–
Remove turn signal glass
1
.
–
Press the bulb carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise all the way.
Turn signal (RY10W / socket BAU15s) ( p. 174)
–
Position the turn signal glass.
–
Insert the screw and turn it counterclockwise first until it engages in the thread with a
light jerk. Tighten the screw slightly.
–
Check that the turn signal system is functioning properly.
14.12 Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
in front of the wall and switch on the low
beam.
Guideline
Distance
A
5 m (16 ft)
–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.