KTM 65 SX 2013, Setup Instructions

Page: 7 / 14

3 WORK
5
601958-10
–
Operate the hand brake lever several times until the brake linings are in contact
with the brake disc.
–
Loosen screws
2
.
–
Pull the front wheel brake and push down hard on the fork several times.
This aligns the fork legs.
–
Tighten screws
2
.
Guideline
Screw, fork stub M6 10 Nm (7.4 lbf ft)
3.4 Adjusting handlebar position
x
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
601951-11
–
Remove the four screws
1
. Remove the handlebar clamps. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
2
. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten the two
screws
2
.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and evenly tighten the four screws
1
.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
3.5 Installing the front fender
700415-01
–
Position the fender with holding lugs
1
into the drill holes on the start number
plate.