KTM 450 XC-W USA, Setup Instructions, Page: 16 / 31

3 WORK
14
B03358-10
–
Press out bearing

using a suitable tool.
Info
Spacing tube

can be pushed aside.
–
Remove spacing tube

.
B03360-10
–
Press out bearing

using a suitable tool.
–
Press in the new bearing

all the way using a suitable tool.
Info
Only press the bearing in via the outer ring; otherwise, the bearing will be
damaged when it is pressed in.
B03417-10
–
Position spacing tube

.
–
Press in the new bearing  all the way using a suitable tool.
Info
Only press the bearing in via the outer ring; otherwise, the bearing will be
damaged when it is pressed in.
B03357-10
–
Grease the new shaft seal rings

and

and press in until they are flush.
Finishing work
–
Install the front wheel. ( p. 13)
3.11 Installing the front fender
K00072-10
Main work
–
Position the front fender. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)