11
SERVICE WORK ON THE CHASSIS
64
V00300-01
Main work
–
Check the throttle cable routing.
Both throttle cables must be routed, side by side, on the back of the handlebars
and above the fuel tank bracket, to the throttle valve body. Both throttle cables
must be secured behind the fuel tank contact area rubber band.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
11.42
Checking the rubber grips
401197-01
–
Check the rubber grips on the handlebar for damage, wear, and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and onto the han-
dle tube of the throttle grip on the right. The left sleeve is clamped onto the
handlebar.
The rubber grip can only be replaced with the sleeve or the throttle tube.
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
F00156-10
–
Check that screw
1
is firmly seated.
Guideline
Screw, fixed grip
M4
5 Nm
(3.7 lbf ft)
Loctite
®
243™
Diamond
A
must be located at the top.
11.43
Adjusting the basic position of the clutch lever
F00157-10
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw
1
.
Info
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
