MAINTENANCE WORK ON CHASSIS AND ENGINE
47
9.41
Handlebar position
0
0
B
B
0
0
B
B
0
0
A
A
0
0
A
A
400223-11
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Distance
between holes
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
from the center.
Distance
between holes
3.5 mm (0.138 in)
The handlebar supports can be mounted in 4 different positions.
9.42
Adjusting handlebar position
x
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0
0
2
2
0
0
1
1
0
0
2
2
0
0
1
1
400223-10
–
Remove the four screws
. Remove the handlebar clamp. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
. Remove the handlebar support.
–
Place the handlebar support in the required position. Fit and tighten the two
screws
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
9.43
Checking gas Bowden cable route
500152-10
–
The two gas Bowden cables must run parallel behind the handlebar down to the
frame. They must be routed directly on the frame above the tank bearing to the car-
buretor.
