14/LIGHTING SYSTEM, INSTRUMENTS
107
400314-01
–
Press the button .
The wheel circumference is displayed in millimeters.
Enlarging the wheel circumference
–
Press the button .
Reducing the wheel circumference
–
Press the button .
–
Press the button
briefly.
–
Press the button
for 3 - 5 seconds.
The settings are stored and the setup menu is closed.
Info
If no button is pressed for 20 seconds, or if no impulse comes from the
wheel speed sensor, the settings are automatically saved and the Setup
menu is closed.
17.5
Setting the clock
Condition
The motorcycle is stationary.
400330-01
–
Press the button
briefly and repeatedly until
CLK
appears at the bottom right of
the display.
–
Press the button
for 3 - 5 seconds.
The hour display flashes.
–
Set the hour display with the button
and/or button .
–
Press the button
briefly.
The next segment of the display flashes and can be set.
–
You can set the following segments in the same way as the hours by pressing the
button
and the button .
Info
The seconds can only be set to zero.
–
Press the button
for 3 - 5 seconds.
The settings are stored and the Setup menu is closed.
Info
If no button is pressed for 20 seconds, or if no impulse comes from the
wheel speed sensor, the settings are automatically saved and the Setup
menu is closed.
17.6
Checking the headlight setting
0
0
A
A
0
0
B
B
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (