KTM 350 EXC-F 2015, Owner'S Manual

Page: 53 / 122

12 SERVICE WORK ON THE CHASSIS
51
101327-10
Main work
–
Remove screws

on the left fork leg. Remove the fork protector upwards.
–
Remove the screws on the right fork leg. Remove the fork protector upwards.
12.10 Installing the fork protector
x
101327-10
Main work
–
Position the fork protector on the left fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the fork legs. x ( p. 50)
–
Install the front wheel.
x
( p. 78)
–
Refit the headlight mask with the headlight.
–
Check the headlight setting. ( p. 88)
12.11 Removing the lower triple clamp
x
Preparatory work
–
Remove the headlight mask with the headlight.
–
Raise the motorcycle with the lift stand. ( p. 48)
–
Remove the front wheel.
x
( p. 78)
–
Remove the fork legs. x ( p. 49)
–
Remove the front fender. ( p. 55)
–
Remove the handlebar cushion.
M00096-10
Main work
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws

and hang the voltage regulator to one side.
–
Release screw

and remove screw

. Take off the upper triple clamp with the
handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
L02471-10
–
Remove O-ring

. Remove protective ring

.
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.