KTM 300 EXC, Repair Manual

Page: 72 / 289

9 SHOCK ABSORBER, SWINGARM
70
9.21 Assembling the rebound adjuster
200808-10
–
Grease O-ring
1
of the rebound needle.
Lubricant (T158) ( p. 270)
–
Mount rebound needle
2
in the piston rod.
Info
Push in the rebound needle to the point where it is possible to mount the
rebound damping adjusting screw.
–
Mount rubber plug
3
.
200809-10
–
Lubricate spring, balls
4
and O-ring
5
.
Lubricant (T159) ( p. 270)
–
Screw in the rebound damping adjusting screw
6
all the way.
–
Mount and tighten screw sleeve
7
.
Guideline
Screw sleeve M14x1 18 Nm
(13.3 lbf ft)
–
Screw out the rebound damping adjusting screw
6
to the stop.
200810-10
–
Grease the O-ring of the rebound damping seat.
Lubricant (T159) ( p. 270)
–
Mount and tighten rebound damping valve seat
8
.
Guideline
Rebound damping valve
seat M8x1 6 Nm
(4.4 lbf ft)
Loctite
®
2701™
Info
The rebound damping valve seat must be pressed inward before tightening.
9.22 Assembling the seal ring retainer
200792-10
–
Mount dust boot
1
with the special tool.
Mounting sleeve (T1204) ( p. 277)
–
Grease the sealing lip of the dust boot.
Lubricant (T625) ( p. 270)
200793-10
–
Grease the O-ring groove.
Lubricant (T158) ( p. 270)
–
Mount O-ring
2
.
–
Mount washer
3
.