7
HANDLEBAR, CONTROLS
54
7.1
Handlebar position
401932-01
On the upper triple clamp, there are two holes a distance of
A
apart.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
B
from the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
7.2
Adjusting the handlebar position
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
101488-10
–
Remove screws
1
. Remove the handlebar clamp. Remove the handlebar and lay it
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
2
. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten screws
2
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
1
and tighten evenly.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
Make sure the gap widths are even.
7.3
Adjusting the basic position of the clutch lever
B01496-11
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw
1
.
Info
When the adjusting screw is turned counterclockwise, the clutch lever
moves closer to the handlebar.
When the adjusting screw is turned clockwise, the clutch lever moves away
from the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
