KTM 250 SX-F 2016, Owner'S Manual

Page: 88 / 118

16 TUNING THE ENGINE
86
16.3 Setting the characteristic map of the throttle response
Info
On the throttle grip, the characteristic map of the throttle response is changed by changing the guide plate.
A guide plate with a different characteristic map is supplied.
H00029-10
Main work
–
Push back sleeve

.
–
Remove screws  and half-shells  .
–
Detach the throttle cables and take off the grip tube.
102246-10
–
Remove guide plate

from handle tube

.
–
Position the required guide plate on the grip tube.
Guideline
The label OUTSIDE must be visible. Marking  must be positioned at mark-
ing  .
Alternative 1
Grey guide plate (79002014000)
Alternative 2
Black guide plate (79002014100)
Info
The gray guide plate opens the throttle valve more slowly.
The black guide plate opens the throttle valve more quickly.
The black guide plate is already mounted when the vehicle is delivered.
H00030-10
–
Clean the outside of the handlebar and the inside of the grip tube. Mount the grip
tube on the handlebar.
–
Attach the throttle cables to the guide plate and route correctly.
–
Position half-shells

, mount and tighten screws

.
Guideline
Screw, throttle grip M6 5 Nm (3.7 lbf ft)
–
Slide on sleeve  and check the throttle grip for ease of movement.
Finishing work
–
Check the play in the throttle cable. ( p. 85)
16.4 Changing the mapping
Info
To be able to enable the desired engine characteristic via the Map
‑
Select riding mode switch in position II , the desired mapping
must first be selected at the Map
‑
Select switch for the basic setting.