BRAKES
70
Info
Never use DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
100807-10
–
Stand the vehicle upright.
–
Remove screw cap
with membrane
and the O-ring.
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
100808-10
–
Remove locking split pins
, withdraw bolt
, and take out the brake linings.
–
Clean the brake caliper and brake caliper support.
100407-10
–
Check that leaf spring
in the brake caliper and sliding plate
in the brake
caliper support are seated correctly.
100408-01
–
Fit the brake linings, insert the bolt, and mount the locking split pins.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
400233-10
–
Add brake fluid to level
.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount screw cap
with membrane
and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
