KTM 2015 200 Duke, Owner'S Manual

Page: 152 / 177

20 TROUBLESHOOTING
150
Faults Possible cause Action
Engine does not crank when the elec-
tric starter button is pressed Operating error
–
Go through the steps of starting the engine.
( p. 60)
Battery discharged
–
Recharge the battery. x ( p. 113)
Fuse 1 , 2 , 3 , or 4 is blown
–
Change the fuses of individual power consumers.
( p. 116)
No ground connection present
–
Check the ground connection.
Engine turns only if the clutch lever is
drawn The vehicle is in gear
–
Shift gear to neutral.
The vehicle is in gear and the side
stand is folded out
–
Shift gear to neutral.
Engine turns but does not start Operating error
–
Go through the steps of starting the engine.
( p. 60)
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Engine has too little power Air filter is very dirty
–
Change the air filter.
Fuel filter is very dirty
–
Check the fuel pressure. x
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Engine overheats Too little coolant in cooling system
–
Check the cooling system for leakage.
–
Check the coolant level. ( p. 131)
Radiator fins very dirty
–
Clean the radiator fins.
Foam formation in cooling system
–
Drain the coolant.
x
( p. 133)
–
Fill/bleed the cooling system. x ( p. 134)
Thermostat defective
–
Check the thermostat. x
Fuse 5 blown
–
Change the fuses of individual power consumers.
( p. 116)