KTM 2014 1190 Adventure, Owner'S Manual

Page: 201 / 228

22 TROUBLESHOOTING
199
Faults Possible cause Action
Engine turns but does not start Coupling of fuel hose connection not
connected
–
Reconnect coupling of fuel hose connection.
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Fuel quality is insufficient
–
Add suitable fuel.
Engine dies during the trip Lack of fuel
–
Refuel. ( p. 94)
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
The engine warning lamp lights
up/flashes Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
The ABS warning lamp lights up ABS fuse is blown
–
Change the fuses in the fuse box. ( p. 163)
Wheel speeds of front and rear wheels
differ greatly
–
Stop, switch off the ignition, start again.
Malfunction in ABS
–
Read out the fault memory using the KTM diag-
nostics tool.
x
High oil consumption Engine oil level too high
–
Check the engine oil level. ( p. 184)
Engine oil too thin (low viscosity)
–
Change the engine oil and filter, clean the oil
screens.
x ( p. 185)
The battery is discharged A power consumer is connected to the
socket/ACC1.
–
Disconnect the power consumer from the
socket/ACC1.
–
Recharge the battery. x ( p. 157)
The hazard warning flasher is switched
on
–
Switch off the hazard warning flasher.
–
Recharge the battery. x ( p. 157)
Battery is not charged by alternator
–
Check the charging voltage. x
Ignition not switched off when vehicle
was parked
–
Recharge the battery.
x
( p. 157)