KTM 2014 1190 Adventure, Owner'S Manual

Page: 149 / 228

15 WHEELS, TIRES
147
S00288-10
–
Push the wheel spindle in all the way and mount chain adjuster
4
and nut
5
.
Info
Mount chain adjusters 3 and 4 in the same position.
–
Push the rear wheel forward so that the chain adjusters are in contact with the tension-
ing screws, and tighten nut
5
.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
B .
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft) Thread greased
S00289-10
–
Insert wheel speed sensor 6 into the hole. Mount and tighten screw 7 .
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
15.5 Checking the rear hub rubber dampers
x
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. The rubber dampers wear out dur-
ing operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub will be damaged.