SERVICE WORK ON THE CHASSIS
46
101336-10
–
Remove O-ring
. Remove protective ring
.
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
10.13
Installing the lower triple clamp
x
(XCF
‑
W, EXC
‑
F EU, EXC
‑
F AUS)
0
0
2
2
0
0
1
1
0
0
3
3
101330-10
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
is correctly positioned.
–
Slide on protective ring
and O-ring
.
101427-10
–
Position the upper triple clamp with the steering.
–
Mount screw
but do not tighten yet.
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
101332-10
–
Position the fork legs.
Info
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
toward the front.
101333-10
–
Tighten screws
.
Guideline
Screw, bottom triple clamp
M8
15 Nm
(11.1 lbf ft)
Summary of Contents for 2012 350 EXC-F SIX DAYS
Page 2: ......
