KTM 1290 SUPERDUKE R, Owner'S Manual

Page: 181 / 213

22 TROUBLESHOOTING
179
Faults Possible cause Action
The combination instrument shows
nothing on the display Fuse 1 is blown
–
Change the fuses in the fuse box. ( p. 147)
The main fuse is blown
–
Change the main fuse. ( p. 144)
The battery is discharged
–
Recharge the battery. ( p. 140)
–
Check the open-circuit current.
The ignition/steering lock is faulty
–
Check the ignition/steering lock.
The engine does not crank when the
electric starter button is pressed The emergency OFF switch is off
–
Press the emergency OFF switch to the posi-
tion
ON .
Operating error
–
Carry out the start procedure. ( p. 75)
The battery is discharged
–
Recharge the battery. ( p. 140)
–
Check the open-circuit current.
The safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
CAN bus communication error
–
Read out the fault memory using the KTM diag-
nostics tool.
Fault in EFI control unit.
–
Read out the fault memory using the KTM diag-
nostics tool.
Fault in the MCU control unit.
–
Read out the fault memory using the KTM diag-
nostics tool.
The engine only turns if the clutch
lever is drawn The vehicle is in gear
–
Shift the transmission to idle .
The safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
The engine turns although a gear is
engaged The safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
The engine turns but does not start The coupling of the fuel hose connec-
tion is not connected
–
Reconnect the coupling of the fuel hose connec-
tion.