KTM 1290 Super Adventure, Owner'S Manual

Page: 231 / 262

22 TROUBLESHOOTING
229
Faults Possible cause Action
Engine turns but does not start Fault in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
Fuel quality is insufficient
–
Add suitable fuel.
Engine dies during the trip Lack of fuel
–
Refuel. ( p. 105)
Fault in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
The engine warning lamp lights
up/flashes Fault in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
The ABS warning lamp lights up ABS fuse is blown
–
Change the fuses in the fuse box. ( p. 189)
Wheel speeds of front and rear wheels
differ greatly
–
Stop, switch off the ignition, start again.
Malfunction in ABS
–
Read out the fault memory using the KTM diag-
nostics tool.
High oil consumption Engine oil level too high
–
Check the engine oil level. ( p. 214)
Engine oil too thin (low viscosity)
–
Change the engine oil and oil filter and clean the
oil screens.
( p. 215)
The battery is discharged A power consumer is connected to the
socket/ACC1.
–
Disconnect the power consumer from the
socket/ACC1.
–
Recharge the battery. ( p. 183)
The hazard warning flasher is switched
on
–
Switch off the hazard warning flasher.
–
Recharge the battery. ( p. 183)
Battery is not charged by alternator
–
Check the charging voltage.
Ignition was not switched off when
vehicle was parked
–
Recharge the battery. ( p. 183)