KTM 1290 Super Adventure, Owner'S Manual, Page: 230 / 262

22 TROUBLESHOOTING
228
Faults Possible cause Action
Combination instrument shows nothing
on the display Fuse 1 blown
–
Change the fuses in the fuse box. ( p. 189)
Main fuse burned out
–
Change the main fuse. ( p. 187)
The battery is discharged
–
Recharge the battery. ( p. 183)
–
Check the open-circuit current.
Ignition/steering lock is faulty
–
Check the ignition/steering lock.
Engine does not crank when the elec-
tric starter button is pressed Emergency OFF switch is off
–
Press the emergency OFF switch to the posi-
tion
ON .
Operating error
–
Carry out the start procedure. ( p. 94)
The battery is discharged
–
Recharge the battery. ( p. 183)
–
Check the open-circuit current.
Safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
ICU is not enabled
–
Activate the ICU.
CAN bus communication error
–
Read out the fault memory using the KTM diag-
nostics tool.
Fault in EFI control unit.
–
Read out the fault memory using the KTM diag-
nostics tool.
Fault in MCU control unit.
–
Read out the fault memory using the KTM diag-
nostics tool.
Engine turns only if the clutch lever is
drawn The vehicle is in gear
–
Shift the transmission to idle .
Safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
Engine turns although a gear is
engaged Safety start system is faulty
–
Read out the fault memory using the KTM diag-
nostics tool.
Engine turns but does not start The plug-in connection of the fuel hose
connection is not connected
–
Connect the plug-in connection of the fuel line.