KTM 1290 Super Adventure, Owner'S Manual

Page: 200 / 262

16 ELECTRICAL SYSTEM
198
16.12 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
M00854-10
–
Remove the screw on the front of the turn signal housing.
–
Carefully remove diffuser

.
–
Press bulb

carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
Turn signal (RY10W / socket BAU15s) ( p. 237)
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
Info
Hook in projection

at recess

.
–
Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.