KTM 125 SX 2016, Setup Instructions

Page: 7 / 22

2 SETUP
5
B02178-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws

. Screw the handlebar clamps so
that both parts touch at the front and tighten all of the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
B02179-01
–
Position the controls on the right half of the handlebar.
B02180-01
–
Position the controls on the left half of the handlebar.
Info
The routing of the cables can be seen in the figure.
–
Mount the fuel tank breather correctly.
–
Install the front wheel. ( p. 8)
–
Install the front fender. ( p. 9)
–
Install the start number plate. ( p. 9)
S00977-01
–
Mount the handlebar cushion.
–
Install the footrests. ( p. 8)
S00978-10
(All XC models)
Warning
Risk of injury Battery acid and battery gases cause serious chemical
burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If
battery acid gets in the eyes, rinse with water for at least 15 minutes
and contact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. ( p. 11)
–
Install the battery. ( p. 12)