KTM 1050 Adventure, Setup Instructions, Page: 6 / 15

2 SETUP
4
–
Check the throttle grip for smooth operation.
M00871-01
–
Mount and tighten the rear mirror on both sides.
S00744-10
–
Remove the film from the headlight. Position the screen. Mount and tighten
screws
 .
S00743-10
–
Mount reflector

with spring washers

on holding plate

.
–
Mount the retaining plate on the license plate holder. Mount the license plate
holder.
–
Carefully loosen and remove the tensioning belt over the swingarm.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the pallet.
S00752-10
–
Remove the radiator shield

.
202186-10
–
Mount rubber dampers  on the engine guard.
–
Position the engine guard. Mount and tighten the screws with the distance sleeves.
Guideline
Screw, engine guard M6 10 Nm (7.4 lbf ft)
–
Recharge the battery. ( p. 6)
–
Store the tool set below the seat.
–
Remove the remaining films.
–
Refuel. ( p. 8)