General
The 1000BASE-T to 1000BASE-SX/LX media converter se-
ries provides 1000Mbps Gigabit Ethernet copper-to-fiber me-
dia conversion, allowing for 1000Base-T-1000Base-X over
multimode or optional single-mode fiber optical media.
Features
•
Gigabit copper to fiber conversion: 1000Base-T-to-
1000Base-SX/LX over multimode or single-mode fiber
•
SFP design : For flexibility, an SFP (Mini-GBIC) connector
is provided for the fiber port to accommodate any type of
SFP fiber transceiver when needed.
•
Support full wire speed copper to fiber conversion
•
Auto MDI/MDI-X detection function on the copper port
•
Auto-negotiation support
•
Plug and play : no configuration settings is required
•
Link Fault Pass Through : this function allows link fault
status passes through between copper link and fiber link
transparently.
•
Far End Fault function on fiber port
•
Transparent conversion to any type of packet frame
•
No packet length limitation
•
Diversified mounting support : desktop mounting, wall
mounting, optional Din-Rail support
•
Center chassis installation : support installation in an cen-
ter chassis rack with benefits of central software manage-
ment and redundant power backup.
•
Support wide range of fiber options : multimode fiber, single
mode fiber (short reach up to long reach), Bi-directional
single fiber, and CWDM optical
•
Low power consumption
Specifications
Twisted-Pair Interface (Copper Port)
Connector
Shielded RJ-45
Signal Compliance
IEEE 802.3ab 1000BASE-T std.
Pin Assignments
Auto MDI/MDI-X detection
Data Speed
1000Mbps
Configuration
Auto-negotiation support
Cable Types
Category 5 or higher UTP
Link Distance
Up to 100 meters
Fiber Optic Interface (Fiber Port)
Signal Compliance
IEEE 802.3z 1000BASE-SX/LX std.
Connector
SFP for pluggable fiber transceiver
Data Speed
1000Mbps, full duplex
Cable Types
MMF - 50/125, 62.5/125
µ
m
SMF - 9/125
µ
m
Link Distance
MMF up to 500m
SMF -model dependent
Eye Safety compliance IEC825 Class 1
Center Interface
Interface
For center chassis mounting
Connector
FutureBus
DC Power Input
Interface
DC Jack (-D6.3mm/+D2.0mm)
Operating Voltages
DC input +4.75V ~ +12.6V
Power consumption
max 2W @+7.5VDC input
Mechanical
Dimension (base)
W 108mm x D 72.5mm x H 23mm
Housing
Enclosed metal with no fan
Weight
205g
LED Indicators
PWR
ON
Power on
OFF
Power off
SFP
ON
SFP transceiver is installed.
OFF
No SFP transceiver is installed.
LINK
ON
Copper-fiber link up
OFF
Copper-fiber link down
BLINK
Copper-fiber link with data traffic
OL
ON
Fiber port optical signal detected
OFF
Fiber port no optical signal
Environmental
Operating Temperature -5
~ 55
o
C
Storage Temperature
-40
~ 85
o
C
Relative Humidity
5% ~ 90%
Approval
FCC Part 15 Class B
CE / CISPR 22 Class B
IEC60950 Safety
Refer to
Model Optical Specification sheet
for model de-
tails. The documentation describes the detailed fiber configu-
ration, rated operating temperature, and optical specification
of each model.
1
2
4
3
Gigabit Ethernet Media Converters
1000BASE-T TO 1000BASE-SX/LX
KGC-300 Series
Installation Guide
DOC.060227-KGC300
