CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020
page
46
of
63
9.4
REMOTE CONTROL
For the remote control of the compressor, activate SWITCH 1 ON and connect your controller to
Pin shown in the picture below:
9.5
AUTOMATIC RESTART
To activate the AUTOMATIC RESTART of compressor, place the SWITCH 2 in the ON position
as shown in the picture below:
ATTENTION
The rules stipulate the need for manual reset of the system in case of arrest for the
absence of voltage. The above-mentioned change is at the discretion of the user,
therefore KTC Srl doesn't accept any responsibility for damage to persons and
property with this type of use.
