EN
FACTORY DATA RESTORAL
CERTIFICATIONS
On factory data configuration there are no
opera
remote commands memorized and the outputs are programmed as indipendent and bistable.
In order to restore the factory default, hold the programmation button on
auxi wls
for 10 seconds while it is in normal working mode. The led on
device stays lit, then starts regularly blinking and finally shortly blinks 3 times, like the first power up. These 3 blinks indicate the restoral of factory data
and
auxi wls
returns to the normal working mode. In case the button is released before the end of procedure (
3 blinks
), if the button is released
while the led stays lit
auxi wls
will enter in the remote commands programmation, if the button is released while the led blinks regularly it will enter
in the outputs programmation, In case of factory data restored,
auxi wls
reacts as a wireless peripheral on panel, considering that there are no
remote commands memorized.
27 / 05 / 2014
The complete Declaration of Conformity for each Device can be found at: www.kseniasecurity.com
Installation of these systems must be carried out strictly in accordance with the instructions
described in this manual, and in compliance with the local laws and bylaws in force. This device has been designed and made with the highest standards of quality and performance adopted
by Ksenia Security. Is recommended that the installed system should be completely tested at least once a month. Test procedures depends on the system configuration. Ask to the installer for
the procedures to be followed. Ksenia Security srl shall not be responsible for damage arising from improper installation or maintenance by unauthorized personnel. The content of this guide can
change without prior notice from KSENIA SECURITY.
Information for users: Disposal (RAEE Directive)
Warning! Do not use an ordinary dustbin to dispose of this equipment.
Used electrical and electronic equipment must be treated separately, in accordance with the relative legislation which requires the proper treatment, recovery and recycling of used electrical
and electronic equipment.
Following the implementation of directives in member states, private households within the EU may return their used electrical and electronic equipment to designated collection facilities free of
charge*. Local retailers may also accept used products free of charge if a similar product is purchased from them.
If used electrical or electronic equipment has batteries or accumulators, these must be disposed of separately according to local provisions.
Correct disposal of this product guarantees it undergoes the necessary treatment, recovery and recycling. This prevents any potential negative effects on both the environment and public health
which may arise through the inappropriate handling of waste.
* Please contact your local authority for further details.
www.kseniasecurity.com
