KSB mini-Compacta 2013w01 Series, Installation & Operating Manual

Page: 46 / 104

7 Operation
46 of 104
mini-Compacta
2317.886/16-EN
Fault message Priority Description Type of message Acknowledge
ment
Warning Alarm
A5 5 Power supply failure
Pump sets 1 and 2 stop.
- ✘ Auto
A6 6 Phase error / phase failure
Pump sets 1 and 2 stop.
- ✘ Auto
A7 7 Leakage motor 1 (Amarex N/KRT)
Pump set 1 stops.
- ✘ Manual
A8 8 Leakage motor 2 (Amarex N/KRT)
Pump set 2 stops.
- ✘ Manual
A9 9 High water alert
Pump sets 1 and 2 stop.
- ✘ Auto
A10 10 External alarm
Pump sets 1 and 2 stop
(can be set via the KSB ServiceTool).
- ✘ Auto
A11 11 Sensor fault
No action
- ✘ Auto
A12 12 Incorrect rotary field of mains supply (phase sequence)
No action
✘ - Auto
A13 13 Undervoltage
(-15 % of nominal voltage 230 V or 400 V)
No action
✘ - Auto
A14 14 Overvoltage
(+15 % of nominal voltage 230 V or 400 V)
No action
✘ - Auto
A15 15 Flat battery
No action
✘ - Auto
A16 16 Service interval system
No action
(deactivated by default; can be set via the KSB ServiceTool).
✘ - Auto
7.3.4 Displaying the alerts list
The alerts list serves to call up alerts / warnings that have been acknowledged but are
still present.
Table 27: Displaying the alerts list
Esc
Step 1: Activating the alerts list
ü Alerts / warnings have been acknowledged but are still present.
(
ð Section 7.3.3, Page 45)
1. If no measured value parameter is active, press the ESC key.
Repeat if necessary.
Step 2: Navigating
1. Use the arrow keys to select parameter P 2.1.1.
ð
After 1.5 seconds the most recent fault message on the
alerts list is automatically displayed.
ð
If further fault messages are present, the next fault
message will be displayed after another 1.5 seconds.
Esc
Step 3: Leaving the alerts list
1. To leave the alerts list press the ESC key.
ð The measured value display is shown.
(
ð Section 7.3.1, Page 42)