6 Operation
22 of 32
AmaSlide
2553.870/01-EN
6.2 Moving the maintenance aid into servicing position
920.01
901.62
920.01
Fig. 15:
Operating position
ü
The pump set is in operating position.
ü
The pump set has been shut down.
ü
All safety regulations have been observed. (
1. Undo and remove hexagon head bolts 901.62 at the pump end.
2. Undo nuts 920.01 at the pump set.
901.62
Fig. 16:
Servicing position
3. Guide the back pull-out unit including motor along the guide rails as far as it
will go.
4. Fit hexagon head bolts 901.62 in their new position in front of the motor-end
roller and tighten them.
ð
The back pull-out unit including motor is now secured on the guide rails in
servicing position.
WARNING
Work on unsecured maintenance aid
Risk of crushing injuries!
▷
Never perform any maintenance/servicing work before the maintenance aid has
been secured in servicing position.
