MADE FROM ABS DIN 7728 PLASTIC
OUTER DIMENCIONS:
WIDTH 30 cm – HIGHT 20 cm
MOUNTING HOLE:
WIDTH 26,7 cm – HIGHT 17,2 cm
RLG 30 DIESEL ENGINE AUTOMATION
MANUAL
Version 2.1
Page 1: ...MADE FROM ABS DIN 7728 PLASTIC OUTER DIMENCIONS WIDTH 30 cm HIGHT 20 cm MOUNTING HOLE WIDTH 26 7 cm HIGHT 17 2 cm RLG 30 DIESEL ENGINE AUTOMATION MANUAL Version 2 1 ...
Page 2: ... 12 or 24 volts depending on the batteries The inputs for the charger the positive of the battery and the D of the charging alternator are analog and internally measured In terminals 20 and 21 an emergency stop switch Normally Closed must be connected otherwise a bridge must be made there in order for the unit to operate at all OPERATION The mode switch in OFF RESET position The unit is not operat...
Page 3: ...rminals 10 and 11 opens again the engine is stopped and everything returns to idle state TEST Mode In this mode the user can check the condition of the batteries as follows With the mode switch in AUTO and while in idle state TEST button is pressed for 4 secs The message TEST START MANUAL OFF is displayed on screen and then the units makes start attempt after start attempt but without letting the ...
Page 4: ...ations For the connection of the charger with the mains network an automatic fuse according its input currents must be used A DC fuse to protect the charger from reverse battery connection is recommended This fuse can be connected in series with one of the charger s output terminals Connection diagram ...
