Turn on the power switch on the power supply. The
turntable display will light on, and indicate 00.0.
Place
and hold
two fingers flat on the touch sensitive sensor,
on the left of the LEDs. The display will flash from 00.0 to
33.3. The platters will start rotating. Correct speed will
be attained in approximately 30 seconds. It could take a
little longer the first few times, as the system will need to
calibrate itself. Placing two fingers on the left again will
turn off the turntable, and the display will read 0.00.
Once the turntable is moving, placing two fingers to the
right of the LEDs will toggle from 33.3 rpm to 45 rpm.
Again, this operation may take a little longer in the
beginning as the system calibrates.
Level the suspended turntable by loosening the screws
at the top of each leg (through the hole at the center
top of leg caps). Level the turntable left to right and
front to back. Tighten the set screws securing the leg
caps to the leg shafts
Connect the female end of the 2 pico cables to the
motor base. Be careful as there is a 3 pin cable and a
4 pin cable.
Connect the male end of the 2 pico cables to the
power supply. Be careful as there is a 3 pin cable and
a 4 pin cable. Connect the power supply to the AC
mains. The power supply AC input voltage is set at
the factory to either 110 volt or 220 volt. If a change
of AC input voltage is required, please contact us so
that you can ship back the power supply for a voltage
change and re-calibration.
19
22
20
23
21
