Krone KW 5.50 / 4 x 7 T, Operating Instructions Manual

Page: 20 / 42

III - 2
Connect the universal drive shaft with guard to the pto
stub of the rotary tedder. Take care to ensure that the
locking device (1) clicks into place. Fit the protective
sleeve again and secure it with a screw. Use the pipe
clamp on the machine side to secure the drive shaft
guard against rotation.
To mount the PTO shaft on the rotary tedder, unscrew
the screw (1) on the rotary shaft protective sleeve (2),
twist the protective socket and the protective tube
against each other and push the PTO shaft protective
sleeve in the direction of the arrow.
3.3.2 Mounting the PTO shaft on the
rotary tedder
KW-0-038
2 1
KW-0-039
1
Only those PTO shafts provided may
be mounted and used.
Note direction of arrow on PTO shaft!
3.3 PTO shaft
The rotary tedder is driven at a maximum pto speed of 540 rpm.
Only fit or remove the PTO shaft if the engine has been switched off and the ignition key has
been removed. Secure the tractor against rolling away. Make sure that the PTO shaft seal
snaps into place. Secure the rotective tube so it does not turn with the shaft.
3.3.1 Adapting the PTO Shaft
• Hold the PTO shaft halves (1) and (2) next to each
other
• Check the overlap of the attachment and protective
tubes
• Shorten the attachment and protective tubes so
they can move freely in all operating positions
• Adapting the length of the shaft is described in
detail in the PTO shaft manufacturer's operating
instructions
Check the swivel space and the free
movement space for the PTO shaft. If the
PTO shaft touches the tractor or the
attachment, this can cause damage.
KW000006
1
2