Krone EasyCut F 320, Original Operating Instructions

Page: 69 / 86

Maintenance - Cutterbar 14
Checking/changing blades 14.3
Original Operating Instructions 150000802_00_en 69
INFORMATION: Only use the locknut (4) once.
„
Turn the locknut (4) from above on the retaining bolt (3) and tighten it, tightening torque,
refer to page 55
.
„
Repeat this process for all blades.
„
Fold down the safety device.
INFORMATION
Clockwise rotating blades can be ordered by stating order number 00 139 889 *.
Anticlockwise rotating blades can be ordered by stating order number 00 139 888 *.
14.3.3 Changing blades for the “blade quick fastener” version
KM000-045
ü
The machine is in the working position,
refer to page 46
.
ü
The machine is shut down and safeguarded,
refer to page 23
.
ü
The safety device has been folded up, Folding up safety device at front.
ü
The area around blades, cutting discs and mower drums is cleaned.
„
To remove the blade (2), push the blade key (1) between the cutting disc (4) and the blade
carrier (3) and push it down with one hand.
„
Check the mounting parts of the blade (2),
refer to page 70
. Also replace worn or damaged
mounting parts.
INFORMATION: The blades for anticlockwise rotating and clockwise rotating cutting discs/
mower drums are different. When mounting the blades, mind the direction of rotation. The arrow
on the blade must correspond to the direction of rotation of the respective cutting disc/mower
drum.
„
In order to insert the new blade (2), push the blade key (1) between the cutting disc (4) and
the blade carrier (3) and push it down with one hand.
„
Guide the blade (2) on the retaining bolt (5) and allow the blade key (1) to return upwards.
„
Repeat this process for all blades.
„
Fold down the safety device.
INFORMATION
Clockwise rotating blades can be ordered by stating order number 00 139 889 *.
Anticlockwise rotating blades can be ordered by stating order number 00 139 888 *.