Operation
8
Net wrapping
8.12
Comprima V 180
Original Operating Instructions 150001053_00_en
81
ð
The net roll (9) is permanently locked in the roll holder (6).
Swivel the roll holder (6) back into the machine and lift it into the lock using the lever (4).
Actuate the wrapping material brake lever (3) so that the roll holder (6) engages with the
wrapping material brake.
When swivelling in the roll holder, ensure that the tension lever (5) is under the net roll (9).
Check that the net roll (9) is aligned centrally. To do this, measure the distances to the left
and right side walls.
RPG000-017
If the net roll (9) has still not been centrally aligned:
Loosen both adjusting rings (8, 11).
Use a mounting lever (12) to push the net roll (9) in the required direction of the arrow until
the net roll (9) is positioned in the centre.
Push both adjusting rings (8, 11) each with a distance of 2-3 mm onto the sleeve (10) and fix
them in this position.
8.12.2
Insert net
WARNING
Risk of injury due to sharp blades at the cutting unit of the tying unit
You may injure your fingers and hands when inserting the wrapping and tying material or
working in the range of the cutting unit of the tying unit.
Always wear protective gloves when inserting the wrapping and tying material and when
working in the range of the cutting unit.
When working in the range of the cutting unit, work particularly carefully and prudently.