Krone Comprima V 180, Original Operating Instructions, Page: 197 / 242

Malfunction, cause and remedy 17
Disturbances at the tying unit or during the tying cycle 17.3
Comprima V 180
Original Operating Instructions 150001053_00_en 197
Possible cause Remedy
The hydraulic cylinder is
leaky.
„
Seal the hydraulic cylinder or have it replaced by a KRONE
service partner.
Disturbance: The tailgate cannot be opened completely.
Possible cause Remedy
The hydraulic hose for "Open/
close tailgate" is not coupled
correctly.
„
Couple the hydraulic hose for "Open/close tailgate", refer to
page 56 .
The hydraulic hose for "Open/
close tailgate and bring pick-
up to transport/working posi-
tion" is not coupled correctly.
„
Couple the hydraulic hose for "Open/close tailgate and bring
pick-up to transport/working position",
refer to page 56 .
Malfunction: The round bale is conically shaped.
Possible cause Remedy
The bale chamber is filled on
one side. „ Fill the bale chamber evenly, refer to page 66 .
The tractor with machine was
driven too quickly at the end
of the baling process.
„
Slow down at the end of the baling process.
Net wrapping: The number of
net layers is too low.
„
Increase the number of net layers via the terminal, refer to
page 118 .
The wrapping material is torn.
„
Use only wrapping material of the designated quality.
KRONE recommends one of the "KRONE excellent"
products, see label on the machine with the number
27 018 640 *.
Disturbance: The round bale has a barrel shape. This causes the wrapping and tying material
to tear in the centre.
Possible cause Remedy
The bale chamber is filled un-
evenly. „
Drive over the swath on alternate sides, refer to page 66 .
The number of layers of wrap-
ping material is too low. „ Increase the number of layers.
Net wrapping:
refer to page 118 .
Chamber film wrapping: refer to page 119
The wrapping material brake
is set too tight. „
Set the wrapping material brake, refer to page 150 .
17.3 Disturbances at the tying unit or during the tying cycle
Malfunction: The wrapping material (net or film) tears directly after tying starts or during the
tying cycle.
Possible cause Remedy
Deposits have caused the cut-
ting unit to drop again directly
after tying starts.
„
Remove deposits from the cutting unit.
The cutting unit has been set
too deep.
„
Check the setting on the cutting unit.
The wrapping material brake
has been set too forcefully.
„
Adjust the wrapping material brake, refer to page 150 .