Krone Comprima V 180, Original Operating Instructions, Page: 162 / 242

16 Maintenance
16.2 Lubrication chart
162
Comprima V 180
Original Operating Instructions 150001053_00_en
16.1.7 Maintenance – every 500 hours
Changing oil
Main gearbox refer to page 173
16.1.8 Maintenance – Every 1,000 round bales
Components
Check rear bale formation conveyor and ad-
just if required refer to page 185
16.1.9 Maintenance – Every 2 years
Components
Have the compressed air tank checked by a
KRONE service partner
Have the pneumatic brake cylinder serviced
by a KRONE service partner
16.1.10 Maintenance – every 6 years
Components
Check hydraulic hoses refer to page 174
16.2 Lubrication chart
NOTICE
Damage to bearing points
When using lubricating greases not approved and when mixing different lubricating greases,
the lubricated parts may be damaged.
„ Only use approved lubricating greases, refer to page 42 .
„
Do not use graphite-containing lubricating greases.
„ Do not mix different lubricating greases.
NOTICE
Environmental damage caused by consumables
If consumables are not stored and disposed of properly, they may escape into the
environment. As a result, the environment will be damaged, even by small quantities.
„
Store the consumables in suitable containers according to the statutory provisions.
„ Dispose of used consumables according to statutory provisions.
The information on maintenance intervals is based on average load of the machine. In case of
an increased load and under extreme working conditions, the time periods must be reduced.
The types of lubrication are marked by means of icons in the lubrication chart, refer to table.