Operation
8
Net and chamber film wrapping
8.16
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
91
Actuate the wrapping material brake lever (3) so that the roll holder (6) engages with the
wrapping material brake.
When swivelling in the roll holder, ensure that the tension lever (5) is under the net or film
roll (9).
Check that the net or film roll (9) is aligned centrally. To do this, measure the distances to
the left and right side walls.
RP000-040
If the net or film roll (9) has not been centrally aligned:
Loosen the 2 adjusting rings (8, 11).
Use a mounting lever (12) to push the net or film roll (9) in the required arrow direction until
the net or film roll (9) has been positioned in the centre.
Push the 2 adjusting rings (8, 11) each with a distance of 1-2 mm onto the sleeve (10) and
fix them in this position.
8.16.2
Inserting the net or film
WARNING
Risk of injury due to sharp blades at the cutting unit of the tying unit
You may injure your fingers and hands when inserting the wrapping and tying material or
working in the range of the cutting unit of the tying unit.
Always wear protective gloves when inserting the wrapping and tying material and when
working in the range of the cutting unit.
When working in the range of the cutting unit, work particularly carefully and prudently.